No Products in the Cart
Arrowzoom Car Insulation Foil Roll is a heat-insulating layer for the insulation of cars. It helps to reduce heat loss and improve noise levels inside the cars.
It is negligible water vapor permanence means no additional vapor barriers or coatings are required.
Made without Ozone destroying agents such as CFCs or HCFCs.
Made from high quality Foam Rubber and Aluminum Foil, thermally fused to pure reinforced aluminum foil. It can solve tight clearance issues with its very low thermal conductivity.
It provides an appearance and performance that remains unchanged for the life of the building without sagging or giving a quilted look.
It contributes to reducing the installation time of mechanical services that may be installed afterward.
It is completely user-friendly and does not emit fibers or dust during installation or in service. It is non-irritant, odorless, and will not support bacterial growth.
Extensively tested to various international fire and smoke standards.
STC (Sound Transmission Class), is a numerical rating of how effective a material is at blocking the transmission of sound through itself. This rating generally applies to hard materials like rubberized sound barriers, concrete, brick and drywall but also applies to a much lesser degree to softer materials like mineral fiber (although it isn’t tested by itself; it’s tested as part of a wall system to verify its effectiveness).
Before applying the insulation mat, clean the surface carefully. Please make sure the surface is clean and dry as any dust on the surface will reduce the adhesiveness of the insulation mat.
Lay the insulation mat out for your specific application. Keep in mind that the insulation mat is evenly distributed throughout the surface of the entire surface of the given element.
Measure the designated areas that need to be field cut on the insulation mat and make the appropriate cuts without removing the adhesive paper (examples would be around beams, doorways, or if a short piece is needed). After all the pieces have been field cut, put the material back in the appropriate position on the wall or ceiling and lightly mark the bottom and side of where each piece will be lightly with a pencil to ensure straight application.
Slowly peel off the adhesive paper and hang the insulation mat on the designated surface. Once you peel off the sticker, the insulation mat should easily stick to the surface of your choice.
Press the mat firmly into place, using a roller for larger pieces. The roller reduces the risk of leaving air pockets, which reduces sound damping capacity. The temperature of the mat and application surface should not be below room temperature during fitting. Heating the material is not necessary.
If you would like to customize the size of the Car insulation mat that you needed, please send an email to us at firstname.lastname@example.org.
Rubber + Aluminum Foil
- 7 mm (0.3 in)
- 10 mm (0.4 in)
50 cm x 100 cm (19.7 in X 39.4 in)
We may split your order into multiple shipments for postage. And due to shipping requirements, we compressed (vacuum sealed) the acoustic foam for easy shipping.
Please kindly give up until 24 to 48 hours for the foam to restore its normal size.
If you are still not sure, feel free to speak to an expert now.
This stuff is so badass! I could not believe how easy it was installing and how much of a difference it made in my truck.
I've only done one side of my vehicle on the floorboard from the front where the pedals are to the back seat and this material has made at least a 20% difference in deadening the sound from the road on the undercarriage. Great for doors, etc. to help acoustics for your sound system.
Moulds very easily & sticks firmly.
What a difference in cabin noise level. I have a Chevy cargo van with no divider so has a lot of road noise. I went a little above and beyond the recommended coverage recommendations and covered whole inside of both doors. Took awhile but well worth the effort. Thinking about doing the rest of the inside. Great product and highly recommend.