No Products in the Cart
All our acoustic panels are non-toxic and environment friendly.
The non-woven cloth covered on the surface protects the fiber from weathering and increases its life span.
Reduce the vibration of the resonance frequency.
Self-Adhesive. East to cut and fit.
The sound deadener material allows you to deal with both, cold and heat. This is especially important in hot climate areas. A well-insulated interior is a pledge of high comfort while in the vehicle. Liner heat shield material will solve the problem of excessive heating if your car is equipped with a powerful engine and an enhanced exhaust system. It is also easy to use Liner as the hood insulation (hoodliner)
The internal porous microfiber can effectively absorb the high frequency noise.
Use it in your Automotives, Home Theaters, Studios or Gaming Room for acoustic treatment / Isolation Shield, or in offices as a Desk Privacy Panel.
STC (Sound Transmission Class), is a numerical rating of how effective a material is at blocking the transmission of sound through itself. This rating generally applies to hard materials like rubberized sound barriers, concrete, brick and drywall but also applies to a much lesser degree to softer materials like mineral fiber (although it isn’t tested by itself; it’s tested as part of a wall system to verify its effectiveness).
Before applying the insulation mat, clean the surface carefully. Please make sure the surface is clean and dry as any dust on the surface will reduce the adhesiveness of the insulation mat.
Lay the insulation mat out for your specific application. Keep in mind that the insulation mat is evenly distributed throughout the surface of the entire surface of the given element.
Measure the designated areas that need to be field cut on the insulation mat and make the appropriate cuts without removing the adhesive paper (examples would be around beams, doorways, or if a short piece is needed). After all the pieces have been field cut, put the material back in the appropriate position on the wall or ceiling and lightly mark the bottom and side of where each piece will be lightly with a pencil to ensure straight application.
Slowly peel off the adhesive paper and hang the insulation mat on the designated surface. Once you peel off the sticker, the insulation mat should easily stick to the surface of your choice. Remove all the air bubbles from underneath by flattening them with your hands.
Use a roller to flatten out the insulation mat. Roll out the surface until it becomes flat and smooth.
If you would like to customize the size of the auto insulation mat that you needed, please send an email to us at service@arrowzoom.com.
Polyester Fiber (PP+PET)
50 cm x 80 cm (19.7 in X 31.5 in)
We may split your order into multiple shipments for postage. And due to shipping requirements, we compressed (vacuum sealed) the acoustic foam for easy shipping.
Please kindly give up until 24 to 48 hours for the foam to restore its normal size.
