No Products in the Cart
Arrowzoom Black Mass Loaded Vinyl is an effective sound control option for architects and engineers. It not only offers astounding sound reducing abilities but is also safe to use and easy to apply. It is typically attached to joists or studs, followed by covering seams and joints with acoustic caulking or barrier tape.
All our acoustic barrier sheets are non toxic and environment friendly
The barrier sheet is fire-retardant. It stops fire from spreading and reduces its intensity.
The best alternative to rubber foam sound deadening is to filter approximately most of the outside noise from entering the room/car. Also, it is a very versatile insulation material with excellent thermal barrier properties.
These mass loaded vinyl are designed by audio engineers that allows anyone who like to improve the sound quality or solve sound issues to save time.
Use it in your Automotives, Home Theaters, Studios or Gaming Room for acoustic treatment / Isolation Shield, or in offices as a Desk Privacy Panel
STC (Sound Transmission Class), is a numerical rating of how effective a material is at blocking the transmission of sound through itself. This rating generally applies to hard materials like rubberized sound barriers, concrete, brick and drywall but also applies to a much lesser degree to softer materials like mineral fiber (although it isn’t tested by itself; it’s tested as part of a wall system to verify its effectiveness).
Before applying the mass loaded vinyl, clean the surface carefully. Please make sure the surface is clean and dry as any dust on the surface will reduce the adhesiveness of the mass loaded vinyl
Lay the mass loaded vinyl out for your specific application. Keep in mind that the mass loaded vinyl is evenly distributed throughout the surface of the entire surface of the given element.
Measure the designated areas that need to be field cut on the mass loaded vinyl and make the appropriate cuts without removing the adhesive paper (examples would be around beams, doorways, or if a short piece is needed). After all the pieces have been field cut, put the material back in the appropriate position on the wall or ceiling and lightly mark the bottom and side of where each piece will be lightly with a pencil to ensure straight application.
Slowly peel off the adhesive paper and hang the mass loaded vinyl on the designated surface. Once you peel off the sticker, the mass loaded vinyl should easily stick to the surface of your choice. Remove all the air bubbles from underneath by flattening them with your hands.
Use a roller to flatten out the mass loaded vinyl. Roll out the surface until it becomes flat and smooth.
If you would like to customize the size of the mass loaded vinyl that you needed, please send an email to us at service@arrowzoom.com.
Polyester Fiber (PP+PET)
- 1.2 mm (0.05 in)
- 2 mm (0.08 in)
- 1m x 1m (39.4 in X 39.4 in)
We may split your order into multiple shipments for postage. And due to shipping requirements, we compressed (vacuum sealed) the acoustic foam for easy shipping.
Please kindly give up until 24 to 48 hours for the foam to restore its normal size.
